Auf einem Windows-System erhielt ich jüngst beim Reboot die Fehlermeldung: “Missing or Corrupt Ntfs.sys”. Natürlich war mein erster Gedanke, dass sich die Platte, das Filesystem oder zumindest diese Datei verabschiedet hatte.
Microsoft gibt dazu unter in der Knowledge Base folgende Information:
“Missing or Corrupt Ntfs.sys” Error Message When You Restart Windows XP After You Convert Your Hard Disk to the NTFS File System
RESOLUTION
To resolve this problem, you must replace the missing or corrupted Ntfs.sys file. To do so, follow these steps:1. Start your computer with the Windows XP CD-ROM in the CD-ROM drive.
2. You are prompted with the following option:
To repair a Windows XP installation using Recovery Console, press R
When you are prompted with this option, press R to select it.3. At the command prompt, type the following commands (press ENTER after each command):
cd \windows\system32\drivers
ren ntfs.sys ntfs.oldNote This step renames the corrupted Ntfs.sys file to Ntfs.old. If the Ntfs.sys file is not found, then the file was missing.
4. At the command prompt, type the following command, and then press ENTER:
copy cd:\i386\ntfs.sys drive:\windows\system32\driversWhere cd is the drive letter for the CD-ROM drive that contains the Windows XP CD, and drive is the drive that you installed Windows XP to.
5. Remove the Windows XP CD from your CD-ROM drive, type quit, and then press ENTER to quit the Recovery Console.
6. Restart Windows XP
Klingt zwar alles ganz plausiebel und so hatte ich es ja auch aufgrund der Fehlermeldung wartet – aber letzlich lag es an defekten RAM!
Ich hatte 2 GB am Jahresanfang gekauft was sich auch im Dauerbetrieb unauffällig gezeigt hatte bis plötzlich dieser Fehler auftauchte und zwar nicht nur sporadisch sondern 100% reproduzierbar. Nur durch Zufall hatte ich in einem Forum aufgeschnappt, dass auch defektes RAM zu dieser o.g. Fehlermeldung führen kann. Da ich das noch das alte RAM rumliegen habe habe ich das wieder verwendet und es klappte auf Anhieb. Bei defekten RAM hätte ich dieses Fehlerbild nicht erwartet. Bluescreen mit PAGE-Fault-Errors usw. ja, aber dieses Fehlerbild passte irgendwie so gar nicht in meine Vorstellung.
Hallo Lars,
also, ich hab die Ntfs.sys kopiert, allerdings hat es immer noch nicht geklappt, kannste mir helfen? meine E-Mail ist: [email protected]
Hallo Jake, wie im Beitrag beschrieben hatte auch bei mir das Ersetzen der Datei Ntfs.sys keine Lösung des Problems gebracht. In meinem Fall war halt das RAM defekt und der Fehler ließ sich nur durch Austausch des RAMs beheben. Daher meinte ich ja auch, dass die Fehlermeldung total irrefühend sein kann…